4 products available
Cable and pipe avoidance and location tool with depth measurement. Simultaneous dual 33+131 kHz frequency will assist in the detection of smaller buried pipes and cables such as telecoms, cast iron and street lighting spurs. 4 available power levels up to 1 watt and depth detection approximately 3 meters (depending on soil type and operating mode). Four detection modes; Power, Radio, Generator and Allscan. Features a Dynamic Swing Sensor to aid in cable and pipe location.
Ideal for tracing cables in walls and underground, locating fuses/breakers on final circuits and locating interruptions and short-circuits in cables and electrical floor heating systems. Can be used for tracing metallic water and heating pipes. Supplied as a kit comprising a transmitter and receiver in a carry case. Voltage measurement range 12 to 400 volts. Frequency range 0 to 60Hz. Transmitter output signal 125kHz. Transmitter voltage 0 to 400V ac/dc. Depth location 0 to 2.5m. Receiver voltage detection range 0 to 0.4m. The receiver incorporates a torch for working in dimly lit locations.
The Megger EZ-Thump is a compact and light weight portable cable fault locations system which is also suitable for This unit incorporates a 12 kV Hipot tester, time domain reflectometer (TDR), and surge generator. It can be powered from an ac supply or internal batteries (3 h recharge time provides 30 m of thumping). Surge generator produces a 500 J, 0 to 12 kV at 12 mA pulse. The kit includes the Digiphone Plus pin-pointer with surge wave receiver to locate faults while thumping.
Time Domain Reflectometer cable fault locator. User selectable ranges from 0 to 50m up to 20km, minimum resolution 0.1m. Dual cursor measurement. Internal memory for 15 traces. Megger "Tracemaster" software supplied. High resolution LCD display. Battery powered. Dust and shower proof to IP54. This system can operate on live cables.
