11 products available
Primary injection testing system consists of a Control Unit and a Current Unit. Up to 1600A output current with cables supplied. Unit is capable of up to 5000A output current with special cables(not supplied). Suitable for switchgear and CT commissioning, ground grid, circuit breaker testing and more
Battery Powered Primary injection, secondary injection, and basic protection test set. Applications include Wiring and polarity checks, Burden measurements, Single-phase protection relay testing, CT / VT ratio checks, Micro-ohm resistance testing. 150 V AC / 220 V DC output (30 VA), 110 A AC / 100 A DC output (600 VA) and Inputs binary wet/dry, AC/DC voltage 300 V or current with shunt. Supplied with Wiring check add-on and Grounding system. Optional HGT1 and HGT1 with PTM software available for step and touch voltages measurement.
CP CR600 is a compensating reactor for the CP TD12 and TD15.Allows testing of the insulation quality of generators, motors and other systems with high capacitances up to 1 µF at rated frequency. Used with CPC 100 + CP TD12/15 for dissipation factor (tan delta) and power factor measurements.
CP TD12 is accessory for CPC 100 for performing power/dissipation factor and capacitance measurements. Suitable to determine a wide range of electric and dielectric parameters: Power factor, dissipation factor (tan d),Capacitance, Exciting current, Watts / power (P, Q, S), Inductance, Impedance, Current, Phase angle, Quality factor
CP TD15 is an accessory for CPC 100 for performing power/dissipation factor and capacitance measurements 15KV. Suitable to determine a wide range of electric and dielectric parameters: Power factor, dissipation factor (tan d),Capacitance, Exciting current, Watts / power (P, Q, S), Inductance, Impedance, Current, Phase angle, Quality factor
Portable (29 kg) primary test system suited for testing of current transformers, voltage transformers, power transformers, power lines, HV cables, grounding systems, switchgear and circuit breakers, protection relays and more. Tests to 800A over frequency range 15Hz to 400Hz, or to 400A DC. Laptop included, preloaded with CPC 100 Toolset and PTM software. Optional accessories: OMI,CPCU1 (with or without OMI,HGT1) OMI,CPSB1 OMI,CP-TD12/TD15, OMI,CP-CR600
Combined with the CPC 100, the CP CU1 is a measurement system for line impedances & k-factors of overhead lines or power cables, mutual coupling of parallel lines, ground impedances of large substations and coupling of power lines into signal cables. This test system overcomes the problem of power system frequency interference that has previously made it necessary to use extremely large, high-power equipment to carry out these measurements.
Switch Box to allow fully automated 3 phase transformer testing, accessory for the CPC100. Requires CPC100 with DEMAG option
HGT1 is a handheld meter to measure ground impedance, step and touch voltages. Applications include measuring Fall of Potential at locations outside the substation to determine the ground impedance and measuring step and touch voltages at multiple locations using the CPC 100 and CP CU1.
HGT1 with PTM software is a handheld meter to measure ground impedance, step and touch voltages. Applications include measuring Fall of Potential at locations outside the substation to determine the ground impedance and measuring step and touch voltages at multiple locations using either Compano 100 or the CPC 100 and CP CU1.
